Arc voltage disable/enable automatically

ilias nt shared this problem 12 months ago
In discussion

Is there any way to disable/enable automatically the arc voltage when im cutting holes, from fastnest 7? Because when im cutting holes the speed change so the arc voltage change too and the torch goes up.

Comments (3)

photo
1

Hi Ilias,

It is likely we can support turning the Height Control off for Small & Medium sized holes (assuming that is what you are looking for here). This can then be turned back on for the rest of your cut.

However, to confirm this we require:

With these, I will be able to check what can be done to enable the THC on / off for you

Cheers,

Alex Fagan

photo
1

The N299.docx is the exported code from the part that i want to cut with some extra lines to explaine where I need the commands. The part shown in the code is the jpg.

photo
1

Hi Ilias,

Thanks for the sample, however, I need the actual M codes you use for THC on and off. Should be something like M14/15. Can you send me a sample of code with these codes applied as you need them?

Also I require a service email of your FastCAM, with the part loaded. This is so I get a copy of the part and can replicate the code accurately, but also, more importantly, so I get a copy of your current POST file, so I can edit in the THC on / off.

Hope to hear from you soon!

Cheers,

Alex Fagan

photo