FASTCAM COMBINATION PROGRAMME

VIKASH RAGHAV shared this question 1 month ago
Answered

RESPECTED FASTCAM COMMUNITY, I THINK you can help me ..

i have a fstcam software and i want to make a programme with mix up three in one programmme like =BRIDGE CUTTING FOR DIAMOND SHAPES PIECES+ COMMON CUTTING FOR SQUARE +SIMPLE CUTTING FOR SINGLE PIECES, WITH THE REQUIREMENT OF THAT I CAN MAKE A KERF CONTROL IS CONTROLLED BY MY MACHINE NOT BY MY SOFTWARE.

WHEN I TRY THISIT CREATES MORE PROBLEM BECAUSE SOME TIMES IT CREATES MORE PROBLEM BECUASE IN SOME PICES IT ADD UP G41 OR G40 BUT IN SOME DOES NOT. WHAT TO DO ? IS I HAVE TO ADD UP OR REMOVE THIS KRF COMMANDS MANUALLY IN EDITING OPTION ?

Comments (1)

photo
1

Dear Vikash,

In either Bridge Cutting or Common Cutting modes, you can still facilitate standard cutting.

But you cannot mix Bridge Cutting mode with Common Cutting mode. It is one or the other mode presently.

You can send us a service email of the nests you're working with if you're interested in discussing this further. Bearing in mind the above that you can only use Bridge Cutting mode vs Common cutting mode but not both at once.

http://response.fastcam.com/knowledge-base/article/ho-do-i-send-a-service-email