How to add preamble and postable to nc files.

faskramerda1 shared this question 3 months ago
Need Answer

After loading dxf file and saving .PTH file, I create a gcode nc file.

How can I automatically add a preamble and postamble to the nc files.

without editing it offline.

Comments (1)

photo
1

Hi faskramera1,

FastCAM Post Processors can be configured to enable COMMENTS. Note the controller side will also need to be to handle comments for this to work.

Can you email attached a sample of the 'preamble' and 'postamble' in a sample file, as part of a service email from your FastCAM software.

http://response.fastcam.com/knowledge-base/article/ho-do-i-send-a-service-email

We can advise further once we have your configuration and sample to review.

regards,