Run time error 340

Hiraman shared this question 3 years ago
Answered

Hi ,

when I open the fastCAM 5.10 it shows the "run time error '340'

Control array element 4 doesn't exist"

When click on OK it disappears.

Please help.

Best Answer
photo

It could be an issue with a temporary file.

Please locate your FastCAM folder:-

C:\Program Files\FastCAM (for 32 bit Windows)

OR

C:\Program Files (x86)\FastCAM (for 64 bit Windows)

Then firstly find the "fastpath.pth" file and delete it.

Then retry FastCAM.


If there is still an issue, then go to the same folder location and locate the "fastcam.tmp" file and delete that one.

Again try running FastCAM.


Please advise if this does not resolve your problem.

Comments (3)

photo
1

It could be an issue with a temporary file.

Please locate your FastCAM folder:-

C:\Program Files\FastCAM (for 32 bit Windows)

OR

C:\Program Files (x86)\FastCAM (for 64 bit Windows)

Then firstly find the "fastpath.pth" file and delete it.

Then retry FastCAM.


If there is still an issue, then go to the same folder location and locate the "fastcam.tmp" file and delete that one.

Again try running FastCAM.


Please advise if this does not resolve your problem.

photo
1

Hi ,

I have tried it but still the problem not resolved.Hence I installed Fast CAM 5.9 it works fine but I want to install the Fast CAM 510 which is easy to operate.

Please help for the same.

photo
1

If you have installed 5.9 and you are installing 5.10 over the top then I would suggest before doing this you delete the following files from the FastCAM folder:

  • *.tmp files
  • *.pth files
  • fastcam_xxxxxxx.txt - where xxxxxxxx will be English, Chinese..... etc


Then install 5.10


If this does not work, then please zip you entire FastCAM folder and email it through to support@fastcam.com.au for further assistance.