unable to select start point, fast plot not opening after nc generated
Received
When I output NC code fast plot is not opening so I can indicate start point rather the message is 'NC program generated in File ....location." The file still cut though the start point was not chosen by be in fast plot. I'm new to this...thanks.
The same problem
Hi Tim,
Sounds like either you don't have view in FastPLOT Turned on. Are you going from FastCAM or FastNEST? and are you in Version 7 or 8?
Cheers,
Alex
Hi Tim,
Sounds like either you don't have view in FastPLOT Turned on. Are you going from FastCAM or FastNEST? and are you in Version 7 or 8?
Cheers,
Alex
Replies have been locked on this page!