Configuring THC for Small Hole Cutting
In Progress
I'm new to plasma cutting and currently using FastCAM with a SteelTailor Legend III plasma cutter. We’re experiencing an issue where the system shuts off while cutting holes because the torch drops in height as the cutting progresses (on holes only)
I suspect this might be related to the Torch Height Control (THC), but I’m having trouble finding the THC settings in FastNest.
Anyone have guidance on where to locate the THC settings? or if there are any specific steps or documentation I should refer to for configuring THC for small hole cutting, I would greatly appreciate it.
Thank you for your help!
The same problem
Hi Rose,
You will likely not be able to find the THC commands in FastNEST itself, as they are often in the POST Processor. Can you send us a service email from your FastCAM and I can have a look further for you:
https://response.fastcam.com/knowledge-base/article/ho-do-i-send-a-service-email
Cheers,
Alex
Hi Rose,
You will likely not be able to find the THC commands in FastNEST itself, as they are often in the POST Processor. Can you send us a service email from your FastCAM and I can have a look further for you:
https://response.fastcam.com/knowledge-base/article/ho-do-i-send-a-service-email
Cheers,
Alex
Replies have been locked on this page!