Ayuda Salida salida de Archivo NC
In Progress
Hola tengo Fastcam con dongle Rojo
Realizo el paso a paso para pasar un archivo dxf y posterior corte en maquina.
El dibujo lo realizo y le doy la ruta de corte, al guardar código NC, lo genera (nombre.NC) pero al ponerlo en la maquina solo se ve el dibujo pero no realiza el corte, tampoco simulación.
Antes el archivo que generaba era un .TXT pero ahora es .NC y no lo reconoce. Ayuda por favor.
The same question
Hello Jose,
The .NC or .TXT is control by the POST PROCESSOR that is selected on installing the product.
This could change if you reinstalled and picked a difference POST PROCESSOR to before.
Have you reinstalled the product? Did you move your FastCAM to a new computer?
You've got a few options here:
A) If you look back at your original documentations/ steps from your OEM Machine supplier you maybe able to figure out which POST PROCESSOR you should pick, reinstall the product and pick the correct POST PROCESSOR.
B) If you changed computers, and the old computer is still available, you can copy the FastCAM folder C:\Program Files (x86)\FastCAM\ from the old PC to your NEW one. That way you transfer the old settings to the new PC.
C) Lastly, you can also send in a copy of the .TXT files that worked for you and we will open a support case and run a check on it, and let you know more information.
regards,
Jackson
FastCAM Support
Hello Jose,
The .NC or .TXT is control by the POST PROCESSOR that is selected on installing the product.
This could change if you reinstalled and picked a difference POST PROCESSOR to before.
Have you reinstalled the product? Did you move your FastCAM to a new computer?
You've got a few options here:
A) If you look back at your original documentations/ steps from your OEM Machine supplier you maybe able to figure out which POST PROCESSOR you should pick, reinstall the product and pick the correct POST PROCESSOR.
B) If you changed computers, and the old computer is still available, you can copy the FastCAM folder C:\Program Files (x86)\FastCAM\ from the old PC to your NEW one. That way you transfer the old settings to the new PC.
C) Lastly, you can also send in a copy of the .TXT files that worked for you and we will open a support case and run a check on it, and let you know more information.
regards,
Jackson
FastCAM Support
Replies have been locked on this page!