FastCAM no sigue las lineas
Need Answer
Desde hace mucho tiempo he estado trabajando con FastCAM 5.10 con el postprocesador Adtech importando archivos de autocad en dxf y no me ha dado inconvenientes, al menos hasta años despues que el dongle (dongle gris) dejo de ser reconocido por el programa.
Ahora he adquirido un FastCAM 7 con dongle rojo, lo instalo con el mismo postprocesador, y haciendo una prueba rapida con un circulo y algunas lineas este opera sin problemas. Unos dias despues necesito hacer algo mas complejo y resulta que el programa no suelta el codigo de corte que deberia, solo se limita a las lineas de desplazamiento, y ni siquiera se toma la molestia de seguir una parte del trazo.
Hi Sergio
Firstly, we recommend you to look at buying a FastCAMv9 subscription with its included priority support to quickly resolve issues likes this.
Looking at these images this looks like a part that will be better output via manual pathing. With just the image however we can't tell any details of your DXF files.
By redrawing a DXF drawn to match your image, both Automatic pathing and manual pathing test results in full NC code output with v7.2.
So the issue is likely a matter of settings and/or pathing steps that you need to take.
For further review, you will need to supply the DXF file in question and a service email from FastCAM:
https://response.fastcam.com/attachments/60?token=b9192aa56c05c3c82b3a0a276f8487a5.pdf
Along with a list of steps of actions taken from load file to output to nc code.
Note that with FastCAMv7 whilst we can check for and confirm limitations in v7, We no longer supply updates to v7.
For updates and fixes, you do need to be on a FastCAMv9 Subscription.
regards
Jackson
Hi Sergio
Firstly, we recommend you to look at buying a FastCAMv9 subscription with its included priority support to quickly resolve issues likes this.
Looking at these images this looks like a part that will be better output via manual pathing. With just the image however we can't tell any details of your DXF files.
By redrawing a DXF drawn to match your image, both Automatic pathing and manual pathing test results in full NC code output with v7.2.
So the issue is likely a matter of settings and/or pathing steps that you need to take.
For further review, you will need to supply the DXF file in question and a service email from FastCAM:
https://response.fastcam.com/attachments/60?token=b9192aa56c05c3c82b3a0a276f8487a5.pdf
Along with a list of steps of actions taken from load file to output to nc code.
Note that with FastCAMv7 whilst we can check for and confirm limitations in v7, We no longer supply updates to v7.
For updates and fixes, you do need to be on a FastCAMv9 Subscription.
regards
Jackson
Replies have been locked on this page!