Run time error 380
In Progress
hi all if i load fast nest7 and i try and open change parameters i get an error Run Time Error 380 ??
any help please as i have to cut some plates.
Files:
run time error...
The same question 
Hi Wayne,
Most likely this is due to a corrupt temporary file, but I cannot say where this file would be (it's location may be part of the issue also). As such I would suggest checking your UAC first, to make sure it is off, and then:
1. Clearing your Virtual Store
2. Clearing your Temporary files
Here is a guide on the UAC and the virtual store:
https://response.fastcam.com/knowledge-base/article/user-account-control-uac-and-fastcam
And here is one on clearing temp files:
https://response.fastcam.com/knowledge-base/article/fastcam-fastnest-clearing-temporary-files_2
Hope that helps!
Cheers,
Alex
Hi Wayne,
Most likely this is due to a corrupt temporary file, but I cannot say where this file would be (it's location may be part of the issue also). As such I would suggest checking your UAC first, to make sure it is off, and then:
1. Clearing your Virtual Store
2. Clearing your Temporary files
Here is a guide on the UAC and the virtual store:
https://response.fastcam.com/knowledge-base/article/user-account-control-uac-and-fastcam
And here is one on clearing temp files:
https://response.fastcam.com/knowledge-base/article/fastcam-fastnest-clearing-temporary-files_2
Hope that helps!
Cheers,
Alex
Replies have been locked on this page!